48" Red Oak Riser
ROR48 Select 48" Red Oak Riser Unfinished
3/4" X 7-1/4" X 48" Stair Riser
Reviewed by 1 customer
Displaying review 1
Comments about 48" Red Oak Riser:
i used this for the risers on my stairs. the boards had good finish and good grains. no complaints
Do you have questions about this product?
AnswerBox - Get answers from Staff Experts and real customers by clicking "Ask a question"
or click here to ask our Customer Service Team
Q:will this work along with a vapor barrier sheeting over cement under floating floor?
Q:We just purchased 400 sq ft of 12mm padded laminate from Lumber Liquidators. We are installing this over 100 year old wood floors. Some slight highs and lows in wood. Very little. What type of underlayment should I use before I lay flooring. Plywood or foam? One room is 10' x 25'.
A:The subfloor should be flat to within 3/16" in a 10' radius.
Q:A previous question asked about the VOCs for this product, your response was "All of our Material Safety Data Sheets (MSDS) are on our website;For complete MSDS information; Please go to our Website @ LumberLiquidators.com and at the bottom of the page click on Flooring 101, type in your product, enter, then click on the PDF to open." I checked there is no information. Please provide any information on VOCs for this product
A:Unfortunately there is no MSDS sheet available for this undelayment.
Q:My condo association requires underlayment have IIC rating of 50 or above, i don't see this number disclosed on the website. May i know if this foam underlayment can achieve this? If no, what product do you recommend? Thanks
A:Please call our Tech and Installation Dept. @ (800) 366-4204 for a detailed answer to your question. Thank you for your inquiry.
Q:I am installing the Dream Home 12mm laminate w/pad. This will be going into a walk-out basement with concrete floor. Would this be okay under or should I use something different?
A:I would recommend our 6 mil poly moisture barrier for this application.
Q:I am installing a 6mm laminate flooring on my 1st and 2nd floor. I have a plywood subfloor. Do i need to use a underlayment that has a mold inhibitor?
A:No. All our underlayment resists mold. Laminate flooring should not installed in any area with mold concerns. Mold will ruin any building of finishing material.
Q:will this be ok for a under floor radiant heat system. the system is water in pex tubing stapled up under the sub floor
A:No we would not recommend this.
Q:can u use this under vinal for kitchen floors
A:No this product is only recommended for 6mm and 7mm laminates without pre-attached foam pad.
Q:Can this product be used under 6mm laminate flooring and over plywood?
A:Yes Dream Home Dream Home Foam Underlayment is recommend for 6mm and 7mm laminate flooring. We recommend laying 15lb felt paper or silicone vapor paper over plywood sub floor and the HF foam on top.
Q:Can I install this underlayment on top of Radiant Heat pads??
A:No I would not recommend this.