I would not use a staple for this species of wood
(5/16” to 5/8”) LOWER PROFILE
Special nailers, shims or shoe accessories are usually required
CLEAT NAILER (example) 18-20 gage cleats
Powernail Model 200p/250m/50p/50m (Pneumatic) Cleat nails 1”- 1 ½ ” long
[EXOTIC WOOD NAILING TIPS]:
Tongue fracture and surface dimpling during installation is common and can be minimized by (1) Installing the flooring in
proper lighting (2) using the correct nail thickness, (3) using the recommended shoe adaptor, or (4) changing the angle of
To further reduce the occurrence of surface dimpling and tongue fracture the use of flooring nailers with a thinner 18-20
gage cleat nail may be needed for the harder exotics species. In addition, many installers will sometimes temporarily adjust
the nailer angle by applying layers of duct tape to the bottom foot plate of the nailer. The use of an over-size base or foot
plate to distribute the nailing force is encouraged. If however, surface dimpling or tongue fracture occurs when nailing the
denser species, drilling pilot holes and hand nailing may be required.
Use caution when fastening the harder exotics with Staplers. The drive bar in Staplers are wider and if fasteners are
overdriven can act like a wood chisel, splitting tongues. Do not mix fasteners when nailing. Staples and cleats hold differently
when mixed can result in irregular seasonal gapping and or movement. When face or top nailing, pick areas of the grain or
pattern that would best hide touch-up fillers.
If nailers prove difficult fastening the lower profile 3/8”or 5/16” floors, many installers will use 100% urethane wood floor
adhesives rather than nailers, especially with the more brittle species like; Australian Cypress, Brazilian Walnut, Teaks.
You can find complete installation instructions on the product page by clicking on the specs tab and then clicking on - Installation Guide.pdf
Thank you for your question.
Answered on 12/1/2011 by customer care 2