Top
Shopping Cart

Flooring Cutter Laminate

SKU: 10024977
Compare to anyone!
Guaranteed low price!
Special Price $9.95/EA
Available in select stores nationwide. Currently not available for online purchase. Check with your local store.
Customer Rating


Flooring Cutter Laminate

The Manual Laminate Cutter will make the job easier! Can handle laminate flooring or fiber board with a maximum thickness of 12mm.

Quick Highlights:
- Dust Free Cutting
- Cuts up to 12mm (1/2") thick
- Quick, quiet and easy to use
- 210mm (8-1/2") straight cutting  
- Free angle cuts and "L" cutting 
- Lengthwise cutting  

Specs:
- Cutting capacity: 215mm (8-1/2") rip cut, angle, notch and lenghwise cut
- Weight: 16.5 lbs.   
  

REVIEW SNAPSHOT®

by PowerReviews
 
2.8

(based on 16 reviews)

Ratings Distribution

  • 5 Stars

     

    (2)

  • 4 Stars

     

    (5)

  • 3 Stars

     

    (2)

  • 2 Stars

     

    (2)

  • 1 Stars

     

    (5)

50%

of respondents would recommend this to a friend.

Pros

No Pros

Cons

No Cons

Best Uses

No Best Uses
    • Was this a gift?:
    • No (14)

Reviewed by 16 customers

Displaying reviews 1-10

Back to top

Previous | Next »

(1 of 1 customers found this review helpful)

 
4.0

Great Cutter

By chi

from columbus

Verified Reviewer

Pros

  • No dust

Cons

  • Took More Pressure To Cut

Best Uses

    Good product, great not having dust, took more pressure to make cut as job progressed. Not sure if it is starting to wear out, we will see with the next job

    • Was this a gift?:
    • No
     
    2.0

    Not easy

    By Bob

    from Phoenix, AZ

    it is hard to cut the flooring - takes a lot of weight/strength. It leaves the flooring with a rough edge. It is easier than running outside to use a table saw and cleaner (no dust).

    • Was this a gift?:
    • No

    (1 of 2 customers found this review helpful)

     
    2.0

    Works but is inefficient

    By EL the handy-woman

    from Duluth, MN

    Pros

    • Cuts Wout Rough Edges

    Cons

    • Hard To Cut Long Cuts
    • Needs A Lot Of Muscle

    Best Uses

      Bought this with the bundle install kit. Works very well and accurately for end cuts of the laminate - 6-8in cuts.
      Takes a lot of manpower - needed my dad to hold board in place when cutting it length wise, then I had to pull down with force to cut. It's possible to use this for an entire project (500 sq ft living room) but it would have taken us a few more days.....ended up using a table saw.

      • Was this a gift?:
      • No
       
      5.0

      i would pay double for this. its great!!

      By todeo

      from Bucks county, PA

      Verified Reviewer

      Pros

      • Cheap No Dustquick

      Cons

      • none

      Best Uses

      • Small rooms

      I bought this and also the small power flooring saw. the manual saw worked so well I did 95% of the job with no power saw at all. no cords no electric place it anywhere u are working and cut away. I am so impressed with this it could and should be 2 times the price. Just amazing. I did you the power saw at the end just because I had about 20 pieces to rip long ways and it was faster to use power saw. I did rip with this saw it worked but required a bit more work to do so. if I only had a couple of rips I would never use a power saw ever.

      • Was this a gift?:
      • No

      (1 of 1 customers found this review helpful)

       
      4.0

      Laminate Floor Cutter

      By Buildiing to Last

      from Venice, Ca

      Verified Reviewer

      To make straight end cuts on laminate flooring in the room you are working in. If you use a compound miter saw it needs to be kept out of the room due to all the dust. With this you can keep the cutter right next to your supply of wood and section of floor you are installing. For angled or someething requiring a sharp clean edge cut, you will still need a traditional compound saw.

      • Was this a gift?:
      • No

      (3 of 3 customers found this review helpful)

       
      3.0

      Okay

      By MMC

      from Boston, MA

      Verified Reviewer

      It cut through 8mm thickness planks as stated. It does take some force to cut through wider planks especially nearer the end of the cut. To a certain extent you need to use the weight of your body to complete the entire cut. The cut leaves a rough edge (approx 3/16" variation in the cut fiber edge and approx 1/16" sporadic damage to the laminate finish edge) which should be okay since the rough edge should be covered by shoe molding. When cutting off small amounts from a plank (less than 1/2 inch) I noticed that the cutter tends to remove material from the underside of the part of the plank you intend to keep. All in all it did the job I asked of it. I prefer using a table saw with a good quality miter fence and laminate saw blade. If you have the option, a sharp laminate saw blade is much more precise in terms of measurement, leaves a much cleaner edge, and cuts the laminate easily.

       
      1.0

      Would not use if free

      By none

      from near Augusta, GA

      Verified Reviewer

      Pros

      • None

      Cons

      • Smashes Flooring
      • Splinters

      Best Uses

      • None

      Circular Saw much better to use. The so called blade is 1/4 or more thick, does not cut. It smashes the flooring.

      • Was this a gift?:
      • No
       
      1.0

      Laminate cutter is stupid for vinyl

      By Christopher

      from Albuquerque, NM

      Verified Reviewer

      Pros

        Cons

        • Cross Cuts Okay
        • Hard To Get Accuracy
        • Slower Than Score Snap
        • Terrible On

        Best Uses

        • Boat Anchor

        Bought this specifically to install vinyl "click" flooring which I bought @ LL. I wanted the install to go faster and cuts to be more accurate. I don't own a table saw or chop saw and didn't want to rent one. I guess if you're installing thicker wood-base flooring this device could be great, for me it was a waste of time and money. Especially awful on "long" cuts. Only when I was 60% finished did I experiment with "score and snap" using a utility knife. The last 40% of the job went twice as fast. Finished project is terrific. Now the slow part is how to get rid of the stupid cutter. Suggest you make sure the store sales people DON'T recommend it for vinyl click flooring.

        • Was this a gift?:
        • No
         
        5.0

        Great Tool

        By D. the biker

        from Defiance, OH

        Pros

        • Great Time Saving Tool

        Cons

          Best Uses

          • Cut Time In Half

          No more running outside to use the saw for cutting the flooring. No mess. Wish we had this for the other 3 room that we did in the past.

          • Was this a gift?:
          • No

          (0 of 1 customers found this review helpful)

           
          4.0

          simple and easy

          By Sparky

          from Auburn, Maine

          Verified Reviewer

          Installed 10 mil flooring with no problem.

          • Was this a gift?:
          • No

          Displaying reviews 1-10

          Back to top

          Previous | Next »